Main content

Measurement setup for the characterization of data converters in a neutron radiation environment

Show simple item record

dc.contributor.advisor Gregori, Stefano
dc.contributor.advisor Gellert, Ralf Boyd, Nicholas 2012-07-10 2012-07-17T19:12:30Z 2012-07-17T19:12:30Z 2012-07-17
dc.description.abstract In this thesis I will present an approach and apparatus for detecting and precisely characterizing any dose-dependent changes in the functional behaviour of a data converter in a neutron radiation environment. Depending on the data converter such changes could include shifts in the gain, offset, noise, or linearity of the device output. The approach leverages the neutron flux produced by an Americium-Beryllium radioisotope neutron source, and is meant to emulate the neutron environment near a Cm-244 source, as found in the sensor head of the APXS instrument. This method uses a relatively low dose rate (configurable by proximity to the source) which allows for long-term monitoring and characterization of parametric changes in device behaviour. It has the additional benefit of not requiring a reactor or accelerator, and can therefore run unattended when necessary. The prototype system, which is designed to allow the data converter to be operating during irradiation, uses LVDS signalling to drive and extract data from a minimal test board which is placed in proximity to the neutron source, and a Virtex-4 FPGA board to provide clock and power, and to perform signal processing. By separating the majority of the test equipment from the neutron environment, any radiation effects will be isolated to the DUT and a minimal set of supporting devices. The prototype design is presented here, along with initial characterization results and first test results on a commercial, off-the-shelf data converter. en_US
dc.description.sponsorship Canadian Space Agency, Ontario Centres of Excellence, MacDonald, Dettwiler, and Associates en_US
dc.language.iso en en_US
dc.rights.uri *
dc.subject data converter en_US
dc.subject ADC en_US
dc.subject radiation en_US
dc.subject neutron radiation en_US
dc.subject neutron damage en_US
dc.subject microelectronics en_US
dc.subject microelectronics radiation damage en_US
dc.title Measurement setup for the characterization of data converters in a neutron radiation environment en_US
dc.type Thesis en_US Engineering en_US Master of Applied Science en_US School of Engineering en_US

Files in this item

Files Size Format View
BoydMAScFinal.pdf 10.45Mb PDF View/Open

This item appears in the following Collection(s)

Show simple item record Except where otherwise noted, this item's license is described as